New Volkswagen Crafter Turbo – Ref. 49377-07535
- 100% secure online payment
- Delivery to your garage or home, anywhere in Europe
- 12-month parts warranty
- Reconditioned and checked turbo
- Part
- Turbo
- Part type
- New turbo
- Make
- Volkswagen
- Model
- Crafter
- Engine
- 2.5 TDI 88 ch, 2.5 TDI 109 ch
- Fuel
- Diesel
- Equivalent references
- 49377-07535, 076145701Q, 076145701QV, 076145701QX, 076145702C, 076145702CV, 076145702CX, 076145702D, 076145702DV, 076145702DX, 49377-07530, 49377-07531, 49T77-07535
- Warranty
- 12 months
An expert is here to help
Not sure you've found the right part?
Restore the full power of your Volkswagen Crafter 2.5 TDI
Behind the wheel of a Crafter, a turbo in good condition makes itself felt immediately: throttle response is crisp from low revs, the loaded van pulls away effortlessly on the road or under a full payload, and the engine no longer smokes on acceleration. Conversely, a worn turbo shows itself through a noticeable loss of power, blue or black exhaust smoke, an unusual whistling noise, and sometimes the engine warning light coming on. This new turbo is designed to restore all the responsiveness you would expect from a light commercial vehicle that is regularly pushed hard under load.
Compatibility with Crafter engines
This new turbo is compatible with reference 49377-07535 and fits the Volkswagen Crafter with the 2.5 TDI 88 ch and 2.5 TDI 109 ch engines, identified by engine codes BJJ, BJK, CEBA and CEBB. Before placing an order, it is essential to check the reference printed on the old turbo or on the vehicle's registration document, as commercial designations can vary depending on the body variant (panel van, chassis cab, combi).
Exchange and warranty
This turbo is sold on an exchange basis: return of the old turbo is required, in accordance with our Terms and Conditions. It is only collected after the new turbo has been delivered and fitted, so your Crafter is off the road for as short a time as possible. The part is covered by a 12-month parts warranty, subject to fitting being carried out by a qualified professional. Payment can be spread over several instalments, in up to 10 instalments.
Tips for a successful installation on your Crafter
On the Crafter's 2.5 TDI engine, turbo failure is most commonly caused by a lubrication fault linked to poor-quality engine oil, missed oil changes, or a clogged air filter allowing contaminants to reach the compressor wheel. A cracked intercooler or split air hoses can also disrupt boost pressure and accelerate wear. Before fitting the new turbo, check the oil circuit (feed and return hoses), the condition of the air intake hoses and clips, and the cleanliness of the air filter. When starting up for the first time, remember to prime the oil circuit before the initial start to ensure immediate lubrication of the bearings.
Restore the full power of your Volkswagen Crafter 2.5 TDI
Behind the wheel of a Crafter, a turbo in good condition makes itself felt immediately: throttle response is crisp from low revs, the loaded van pulls away effortlessly on the road or under a full payload, and the engine no longer smokes on acceleration. Conversely, a worn turbo shows itself through a noticeable loss of power, blue or black exhaust smoke, an unusual whistling noise, and sometimes the engine warning light coming on. This new turbo is designed to restore all the responsiveness you would expect from a light commercial vehicle that is regularly pushed hard under load.
Compatibility with Crafter engines
This new turbo is compatible with reference 49377-07535 and fits the Volkswagen Crafter with the 2.5 TDI 88 ch and 2.5 TDI 109 ch engines, identified by engine codes BJJ, BJK, CEBA and CEBB. Before placing an order, it is essential to check the reference printed on the old turbo or on the vehicle's registration document, as commercial designations can vary depending on the body variant (panel van, chassis cab, combi).
Exchange and warranty
This turbo is sold on an exchange basis: return of the old turbo is required, in accordance with our Terms and Conditions. It is only collected after the new turbo has been delivered and fitted, so your Crafter is off the road for as short a time as possible. The part is covered by a 12-month parts warranty, subject to fitting being carried out by a qualified professional. Payment can be spread over several instalments, in up to 10 instalments.
Tips for a successful installation on your Crafter
On the Crafter's 2.5 TDI engine, turbo failure is most commonly caused by a lubrication fault linked to poor-quality engine oil, missed oil changes, or a clogged air filter allowing contaminants to reach the compressor wheel. A cracked intercooler or split air hoses can also disrupt boost pressure and accelerate wear. Before fitting the new turbo, check the oil circuit (feed and return hoses), the condition of the air intake hoses and clips, and the cleanliness of the air filter. When starting up for the first time, remember to prime the oil circuit before the initial start to ensure immediate lubrication of the bearings.
Frequently asked questions
Everything you need to know before ordering your part.
